[. . . ] CAUTION: A CAUTION indicates a potential for property damage, personal injury, or death. ____________________ Information in this document is subject to change without notice. Reproduction in any manner whatsoever without the written permission of Dell Computer Corporation is strictly forbidden. [. . . ] Reproduction in any manner whatsoever without the written permission of Dell Computer Corporation is strictly forbidden. Trademarks used in this text: Dell, the DELL logo, and Latitude are trademarks of Dell Computer Corporation. Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Dell Computer Corporation disclaims any proprietary interest in trademarks and trade names other than its own. A00 Replacing the Display This document describes how to replace the display in your Dell Latitude C400 computer. The display and the top cover of the computer are designed to be removed and replaced as one unit. CAUTION: Before performing the following procedures, read "Safety and EMC Instructions: Portable Computers" in your System Information guide. Removing the Display NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer. Use the pull tab to pull the securing board up out of its connector. Replacing the Display 7 w w w. c o m 9 Pivot the display upright and lift it out of the computer. 8 Re plac ing the Display Installing the New Display 1 Position the replacement display upright and align its hinges with the slots at the back corners of the computer. Ensure that the display cable assembly is positioned well in front of the display to avoid trapping or pinching the cable when you insert the display. Carefully insert the display hinges into the slots. 2 3 Ensure that the display is fully seated, and then carefully pivot it back until it is completely open. Replacing the Display 9 w w w. c o m 4 Press the display-cable securing board firmly into its connector in the computer base, and replace the two 12-mm screws you removed in step 8 of the previous procedure (or use the new screws provided with the display kit). 10 Re plac ing the Display 5 Close the display, turn the computer over, and replace the two 6-mm screws at the back corners of the computer. 6 Turn the computer right-side up, open it all the way, and replace the center cover: Carefully position the cover, and then press down first on the center and then on the back ridge of the cover to snap those areas into place. Then press the rest of the cover down, working outward toward the ends. 7 To replace the battery, slide it into the battery bay until the latch release clicks. Replacing the Display 11 w w w. [. . . ] Carefully insert the display hinges into the slots. 2 3 Ensure that the display is fully seated, and then carefully pivot it back until it is completely open. Replacing the Display 9 w w w. c o m 4 Press the display-cable securing board firmly into its connector in the computer base, and replace the two 12-mm screws you removed in step 8 of the previous procedure (or use the new screws provided with the display kit). 10 Re plac ing the Display 5 Close the display, turn the computer over, and replace the two 6-mm screws at the back corners of the computer. 6 Turn the computer right-side up, open it all the way, and replace the center cover: Carefully position the cover, and then press down first on the center and then on the back ridge of the cover to snap those areas into place. [. . . ]